Bella Grey Concrete Baby bouncer

Bella can run on four LR14 batteries or with a power adapter. The batteries and power adapter are not included. Insert the batteries according to the polarity markings; do not mix new and old batteries or different types. Remove the batteries if the bouncer will not be used for an extended period, and remove depleted batteries as well.

To power Bella from a mains socket, connect the USB cable to the power adapter, then plug the adapter into the socket. Insert the other end of the cable into the DC port on the bouncer base. Use only a power adapter with the following specifications: 5.8 V DC 0.8 A, and regularly check the condition of the cable, plug and contacts.

First, remove the battery compartment cover by unscrewing the screw with a screwdriver. Insert the batteries into the compartment according to the polarity markings. Finally, replace the cover and tighten the screw.

The bouncer is correctly attached when you hear a click after placing its supports on the base. Connect the front and rear sections of the frame by joining the tubes marked with the same letter, and place the metal tabs into the corresponding holes. Fit the cover and fully fasten the zip; do not use the bouncer with the zip open. To remove the bouncer from the base, press the release buttons on both sides of the mounting component.

Adjust the harness to your child’s height and fasten it correctly before using the bouncer. Release it using the button on the buckle, pass it through the appropriate openings in the cover, insert it into the buckles at the back of the seat and tighten it. Once your child is in place, fasten the buckle clips and the cover’s hook-and-loop fasteners; a click confirms that the buckle is fastened. Do not use the bouncer if the harness is not fastened correctly.

Bella can be rotated 360° and positioned in the direction you choose. Change the seat position by pressing the adjustment buttons on both sides of the frame and selecting the upright, lying or semi-reclined position. Connect the device to a power source or insert the batteries, switch it on using the control panel or remote control, then choose one of five rocking speeds.

With the Bella bouncer, you can choose one of six rocking modes and one of five movement speeds. The first mode automatically changes the rocking pattern approximately every 16 seconds. Night mode, selected on the control panel or with the remote control, gradually slows the rocking until it stops.

When Bella detects your baby's movement, it automatically switches on the rocking motion and melody. You can activate this function using the button on the control panel or remote control. Pressing the button again switches off motion detection.

Switch on a melody using the melody button on the control panel, then press it again to switch it off. Press and hold the button to change the volume. The remote control lets you select a melody, move to the next or previous one, and increase or decrease the volume.

Clean small stains on the cover with a damp cloth and mild cleaning product. The removable cover can be hand-washed at a temperature of up to 30°C, using a mild laundry detergent. Do not use bleach or strong cleaning products, and do not machine-wash or tumble-dry it. Lay the wet cover flat until completely dry. Wipe the frame and plastic elements with a damp cloth, dry them before the next use, and store the product in a dry place.

Bella can run on four LR14 batteries or with a power adapter. The batteries and power adapter are not included. Insert the batteries according to the polarity markings; do not mix new and old batteries or different types. Remove the batteries if the bouncer will not be used for an extended period, and remove depleted batteries as well.